Products

Conical Strainers

    Conical Strainers are very low cost protection for process equipment against damage causing contamination present during Start-up and Commissioning. Conical strainers are for temporary use and thrown away after initial cleaning of the system.

     The downside to a Conical Strainer is they are sandwiched between two flanges therefore requiring an accessible section of pipe, such as removable spool pieces. Conical strainers can be manufactured in a range of different configurations to suit your specific requirements, size, length, filtration level, identification marks, supports…etc.

Conical Strainers are very low cost protection for process equipment against damage causing contamination present during Start-up and Commissioning. Conical strainers are for temporary use and thrown away after initial cleaning of the system.

    Conical strainers can be manufactured in a range of different configurations to suit your specific requirements, size, length, filtration level, identification marks, supports…etc

 

Conical

Sizes: 0.5" (15mm) to 30"+ (750mm+)

Various S/S, Monel, Duplex, Carbon

Maximum pressure rating class 2500lb+ (172 BarG+)

 

High Pressure

Sizes: 0.5" (15mm) to 30"+ (750mm+)

Various S/S, Monel, Duplex, Carbon

Maximum pressure rating class 2500lb+ (172 BarG+)

 

Witches Hat

Sizes: 0.5" (15mm) to 30"+ (750mm+)

Various S/S, Monel, Duplex, Carbon

Maximum pressure rating class 2500lb+ (172 BarG+)

 

Wedge Wire

Sizes: 0.5" (15mm) to 30"+ (750mm+)

Various S/S, Monel, Duplex, Carbon

Maximum pressure rating class 2500lb+ (172 BarG+)